Gone Fishing!
Share your unusual application stories with us
Every month MMT publishes case studies both in print and online. As the author of many of these case studies, I am constantly fascinated at the success stories mold manufacturers share about the challenges they face, a new product or technology they discover to address a specific issue or challenge, and the myriad of benefits they realize once the solution is applied—whether it be leadtime reduction, money saved or quality improvements. It is an added bonus for me when an unusual application is highlighted. Case in point: Damon Weaver, president of Xcentric Mold & Design—a low-volume, short-run, complex custom mold specialist—used KeyCreator from Kubotek USA to produce a fishing rod holder efficiently. Read here about how Damon did it, and send me your unusual application stories!
Related Content
-
How Hybrid Tooling Accelerates Product Development, Sustainability for PepsiCo
The consumer products giant used to wait weeks and spend thousands on each iteration of a prototype blow mold. Now, new blow molds are available in days and cost just a few hundred dollars.
-
MMT Chats: Digitalizing Mold Lifecycle and Process Performance
MMT catches up with Editorial Advisory Board member Bob VanCoillie senior manager of Kenvue’s mold management center of excellence outside of Philadelphia to discuss mold management via tooling digitalization and OEM expectations and opportunities.
-
Hammonton Mold, ADOP France Forge Strategic Partnership in Injection Blow Moldmaking
Hammonton Mold Inc., a leading full-service mold shop based in New Jersey specializing in injection blow molds (IBM), proudly announces its official partnership with ADOP France, a prominent IBM mold manufacturer based in Normandy, France.