Four Micro Tooling Considerations

Metrology is an enabling technology and today’s options provide invaluable insight concerning the demands of micro-size tooling and parts. Metrology equipment and skills are used to measure steel details in the mold, part features/dimensions to ensure the parts meet print tolerance and to guarantee a capable process.

Typically, shops use high-end optical white light interferometer-based metrology systems to validate parts and vision systems to analyze and validate the intricacies of the steel micro molds. The use of such metrology equipment and expertise can provide data and immediate feedback that helps to determine if steel in the mold is acceptable, or if adjustments are required.

The importance of metrology and validation in micro moldmaking is in large part due to specific contingencies that exist in this niche of the industry that can impact design parameters and, ultimately, the integrity of the finished tool and finished part.

Four issues of concern are gating, ejection, mold splits and direction of pull.

1. Ejection & Gating: Ejection or gating is often ignored as parts get smaller, but must be considered if you want to optimize the mold build process. For example, having a small ejector pin on a thin and deep feature can make burning a start hole difficult or impossible, or gating in a thin area when there are other thick areas on the part can cause non-fill and sink.

Also, when planning gating and ejection, anticipate some gate vestige or flash. This preparation during a mold split decision can turn a simple tool build into a very complex one, or it can turn a mold that was going to be very difficult to run into one that runs exceptionally well.

Micro molding involves extremely small parts with exacting tolerances, so the importance of validation and metrology is vital.

2. Split Lines: Changing an ideal split line can cause unforeseen consequences to the mold. For example, a slide with a large surface area may cause injection pressure to flex the mold. A shutoff in the direction of pull will provide a more robust shutoff. 

The direction of the clamp holds a shutoff together as a direct result of clamp tonnage. However, a slide is a factor of the tonnage reduced by the heel angle and strength surrounding mold steel.

3. Feature Size: Part design can significantly impact electrode manufacturing. For example, if there is a square counterbore with sharp corners, you may need four different electrodes to create the feature. If the part had radii added at the corners, this might be possible using only one electrode.

When it comes to ensuring a part will release from the cavity, consider draft, especially when dealing with very small features. Draft is often an oversight with small parts because the amount is so small. 

4. Assembly: Part assembly is an important consideration when optimizing the final part and simplifying the tool build. When building a mold, it’s easy to think that you must machine everything exactly to size. However, sometimes it is better to add clearance to minimize the number of areas that require accuracy.

Adding clearance enables the mold builder to use a less accurate method for certain parts and leave the accurate machining for areas where it is necessary, which saves time. Clearance on the molded parts can be approached the same way.

Micro molding involves extremely small parts with exacting tolerances, so the importance of validation and metrology is vital. There are specific issues that are unique to micro mold manufacturing, and the ability to design a tool with these in mind and also to validate the integrity of the finished micro mold before production are vital to a project’s success.