Additive Manufacturing Users Group to Install New Board
The Additive Manufacturing Users Group (AMUG) installed its 2019-2020 board on July 1, 2019.
The Additive Manufacturing Users Group (AMUG) installed its 2019-2020 board on July 1, 2019. The nine-member board is comprised of both elected and appointed positions, and each board member serves as an officer of the organization. The board’s primary responsibilities will be to build and oversee the 2020 AMUG Conference and architect an organizational structure that will support the ongoing growth of this annual event.
Carl Dekker of Met-L-Flo, who has served two terms as vice president, will take on the role of president. Dekker replaces Paul Bates of UL, who opted not to run for re-election after serving two terms as president, and Bates will assume the role of past president. Andrew Allshorn of At 3D-Squared, who has served as an AMUG global ambassador, was elected for the vice president position that was held by Dekker.
Three incumbents sought re-election and retained their positions. Jamie Cone of BD will serve a third term as vice-president, and Leslie Frost of GE Additive will serve a second term as secretary. In his twenty-sixth term, Thomas Sorovetz of FCA will once again serve as AMUG’s event manager.
AMUG members elected these individuals during the annual conference that was held in Chicago, Illinois. Candidates for the appointed positions of chairman, treasurer and AM industry advisor were proposed and accepted by the elected officers. Filling these positions are Gary Rabinovitz, chairman; Vince Anewenter, treasurer; and Todd Grimm, AM industry advisor.
Carl Dekker expressed gratitude for Mark Barfoot’s years of service. Barfoot, who is stepping down from past president, has served nine consecutive terms in roles that included vice president, president and past president.
Here is a list of the 2019-2020 AMUG Board members:
- President: Carl Dekker, Met-L-Flo
- Past President: Paul Bates, UL
- Vice President: Jamie Cone, BD
- Vice President: Andrew Allshorn, At 3D-Squared
- Event Manager: Tom Sorovetz, FCA
- Secretary: Leslie Frost, GE Additive
- Chairman: Gary Rabinovitz, Reebok
- Treasurer: Vince Anewenter, Milwaukee School of Engineering
- AM Industry Advisor: Todd Grimm, T. A. Grimm & Associates
Related Content
-
It Starts With the Part: A Plastic Part Checklist Ensures Good Mold Design
All successful mold build projects start with examining the part to be molded to ensure it is moldable and will meet the customers' production objectives.
-
Solving Mold Alignment Problems with the Right Alignment Lock
Correct alignment lock selection can reduce maintenance costs and molding downtime, as well as increase part quality over the mold’s entire life.
-
Revisiting Some Hot Runner Fundamentals
What exactly does a hot runner do? If you’ve been in the injection molding industry for any length of time, you might think the answer is obvious, but it is not.
